The geometrie looks not so perfect, the black & white stripes should be on the same level left and right. Try to orientate the positions by using the holes of the mask as fix-points. Also the logo on the top looks a little bit weired.
Here comes the hart part: In this case i usually take the original logo and put the texture from the mask on it. This takes a lot of time and is a fussy work! Same for the numbers, find a font that matches an than use the mask to retexture the font.
Just remember: quality should always be more important than speed.
Thanks I will make it perfect over the week before I release it to the pack. So use Logos off the mask or designs from it. Stretch to holes and match. Okay. Will on it. Thanks man.